MUST High-Temp Silicone Gasket Maker GRAY 300ml

Part No: MGMPG-302
Packaging:300ml
Contain:24pcs
Measurment:30*20.5*24.5cm
G.W.:9.1kg
 

Description

MUST HighTemp Silicone Gasket Maker GRAY is a single component, room temperature vulcanizing gasketing compound designed to provide reliable “formed place” gaskets for mechanical assemblies. This material cures on exposure to moisture in the air to form a tough, flexible, silicone rubber gasket. The product resists aging, weathering and thermal cycling without hardening, shrinking or cracking. Designed to perform under the higher load conditions of engines with closely spaced bolt patterns.

Features

Intermittent Temperature range 500℉(260℃)

High load resistance

Improved oil resistance

Replaces most cut gaskets

Can be used as a gasket maker or dressing

Non-flammable, Non-toxic

Areas of Use

•Valve covers

•Transmission pans

•Oil pans

•Timing gear covers

•Differential covers

Application

1. Remove any previous gasketing materials from mating surfaces.

2. Ensure surfaces are clean, dry and free of loose materials, dust, grease, rust and other contaminants.

3. Remove the cap from the tube and pierce the seal with reverse side of cap. Attach extension nozzle which can be cut to desired bead width.

4. Apply a continuous bead of silicone to mating parts, making sure to surround all bolt holes.

5. Assemble parts and allow to cure. Material dries tack free within 3-10 minutes and fully cures in 24 hours.

6. After use allow excess sealant to extend beyond extension nozzle to cure. To reuse, remove the cured plug from tip of extension nozzle.

Storage

When stored in the original unopened containers at or below 90°F (32°C), it has a shelf life of 12 months from date of production.

In Countries where high heat and humidity are a factor, special precautions must be taken. Store product in a covered, well-ventilated warehouse and avoid excessive heat conditions. Storage in high heat, high humidity conditions may reduce shelf life by up to 30%.