MUST Rearview Mirror Adhesive

MUST Rearview Mirror Adhesive is two parts component glue, but notice no mixing of the two parts. It is extremely strong and has fast acting. It outperforms epoxy and super glue type products Holds up well in high temperature and humid environment. There is no need to mix these two parts.

REARVIEW MIRROR ADHESIVE 

Excellent Bonding for Glass & Mental

IMPORTANT: READ INSTRUCTIONS CAREFULLY BEFORE MOUNTING MIRROR!

*If button is mounted incorrectly. DO NOT ATTEMPT TO REMOVE Bond another over the original one 

*Repair at temperatures between 50F and 75F[10℃ to 24C].

*DO NOT use on plastic buttons

Descripition 

Rear View Mirror Adhesive is two parts component glue, but notice no mixing of the two parts It is extremely strong and has fast acting. It outperforms epoxy and super glue type products Holds up well in high temperature and humid environment. There is no need to mix these two parts.

1:Remove mounting button from mirror bracket. Make note which side faces upwards

2:0n outside of windshield, circle with a crayon to identify old location of mirror button

3:Thoroughly scrape windshield glass and button to remove all old adhesive. All old adhesive must pe removed in order for new application to adhere.

4:0pen Cleaner/Activator Towelette by puling both sides of protective packet at the point at top of .package. Fold packet back to use. Towelette is to remain attached to packet.

5: 0n inside of windshield, clean marked area and prime with Cleaner/Activator Towelette. Allow to dry for 20 second. DO NOT TOUCH windshield after the activator has been applied.

NOTE: Do not wipe the button with the Cleaner-Activator Towelette

6. Remove twist off cap then cut off adhesive tip. Apply one [l] drop of adhesive to the center of button only; NOTE: DO NOT apply adhesive to both button and glass as adhesive will not work properly.

7: lMMEDlATELY apply the button to the windshield, ensuring that the correct side is facing up, and. hold firmly in place for l minute. Allow to set for 30 minutes prior to mounting mirror.

Specifications

1. Simple and Easy to use

2. Excellent Bonding for glass & Metal

3. Cure within Minutes

4. No mixing

5. No clamping required